Choose the house

Number of sections and floors:

1 section, 25 floors,

  • 1st floor –office areas and post office ;
  • 2-25 floors – apartments.
Structure scheme:
monolithic ferroconcrete frame.
Walls:
  • exterior – ceramic tiles 250 mm thick, and monolithic ferroconcrete thick 250 and 300mm,with external insulation system over the external system of ventilated facades, in loggias and balconies – external insulation system and with decorative plaster finish;
  • interior between apartments – ferroconcrete 250 and 300 mm thick and ceramic bricks 250 mm thick.
Partition walls:
  • between rooms – concrete blocks 100 mm thick;
  • bathrooms – ceramic bricks 120mm thick.

Plaster finishing layer is made only over brick walls and partition walls, except bathrooms.

Floor height:
3,00 m (floor to floor).
Overlapping:

monolithic ferroconcrete 200mm thick. In the apartments the finishing works on the floor 80 mm thick is made, except the bathrooms. In the apartments` bathrooms hydro isolation system is made.

Loft (attic):
cold, semi-path through, 1,6 m height.
Roof:
flat, roll coating
Characteristics of fire prevention measures:
  • Lighting of stairs - daylight, at night time –  electric;
  • Antismoke protection – according to the project;
  • Installed fire extinction pipes on every floor
  • Installed fire extinction pipes in bathrooms in the apartments (FEP)
Garbage chute (location):
  • garbage receiver – on each floor(except 1st floor
  • collecting bin – on the 1st (ground) floor.
Number of elevators– 3:
  • 2 elevators 400kg capacity ;
  • 1 elevator 1000 kg capacity (also for firemen transportation).
Additional interior works:
  • Entrance door to the apartment –  metal,shockproof;
  • Interior doors in the apartment –not installed;
  • Windows and balcony doors – plastic with double glazing.
  • glazing of balconies and loggias – plastic with single glazing.
Interior finishing works in the apartments:

not made.

Bathroom equipment:
not installed.
Towel dryers:
electric, not installed.
Type of oven:
electric, not installed.
Wiring:
made of copper wires with installation of sockets and switches
Telephone cable, TV:
Wires (connection) performed to the boards on each floor at the corridor of common use. Connection to the apartment and interior layout not made.
Heating system:

Two- piped dual-zoned wiring, with low dilusion:

  • first zone – 1 – 13 floors,
  • second zone – 14 – 25 floors.
The wires of heating system made to every apartment of polyethylene pipes in the floor structures.
Type of heating device:

steel radiators

Ventilation system:
Mandatory, in the kitchen and in bathrooms wall ventilators are installed.
Cold water supply:

Two-zoned.

  • Firstzone – 1 – 13 floors inclusively (water supply - ascendant
  • secondzone – 25 – 14 floors, inclusively (water supply  - descendant).

Second zone pipelines laid under the ceiling of corridors of common use on the 25th floor.

Hot water supply:

Dual- zoned :

  • Firstzone – 13 – 1 floors inclusively (water supply - descendant). First  zone pipelines laid under the ceiling of corridors of common use on the 13 th floor.;
  • secondzone – 25 – 14 floors inclusively (water supply - descendant). The pipelines laid under the ceiling of corridors of common use on the 25 th floor.

Circular pipelines of second zone are located under the ceiling of corridors of common use on the 13 th floor.

Each apartment dilution of hot and cold water from pipes, placed in corridors of common use, bathrooms and kitchens to the apartments is done with polyethylene  pipes in floor structures.
Counters for each apartment:
  • cold and hot water;
  • electricity;
  • heating

Located in the corridors of common use blocks.

Finishing works on the corridors of common use:

Elevator hall, corridors of common use and stairs:

  • stairs floor –  concrete finish;
  • corridor of common use and elevator hall floor –  ceramic tiling;
  • elevator hall walls on the 1st floor –  ceramic tiling;
  • corridor of common use  and elevator hall walls at the typical floors – water resistant paint;
  • ceiling – paste whitewash;
  • entrance doors to the building – aluminum glazed;
  • interior doors –wooden;
  • windows – metal glazing.
Embellishment:
  • exterior lighting – according to the project;
  • roads, pavements, pedestrian paths – asphalt coating and FEM coating;
  • recreation areas: active rest, playground, temporary parking for vehicles.
Attention to the investors!

1. Itisforbiddentodismantleindependentlytheconstructiveelementsoftheobject, interior and exterior worksandchangetheengineeringcommunications.

2. Duringtheconstructionprocessthedeveloperhastherighttoadd/ changeelements in the design and technological solutions of the residential building that do not degrade its consumer qualities and do not lead to violation of sanitary norms.

3. The total area of the apartment is approximate; final calculations should be made according to the official data of technical inventory.